Par2: Retaining toolbox positions between runs 2000-04-03 -- Kevin Erskine I found the answer (thanks to Kevin Erskine!). If you just plunk the code in using the Save and Restore Window Location check box, it doesn't work. In fact, you need to turn this off and store only the x and y position (at least in Legacy). You have to: 1. Open the window and DOCK it 2. In the EVENT:SIZED, this is where you set the x and y positions. Do not set the width and height for the window. For some reason, trying to set it anywhere else (like right after docking) didn't work for me. Now, it works fine! Printed November 21, 2024, 7:18 am This article has been viewed/printed 35209 times. |