Par2: Using CHAIN.COM in XP 2004-06-03 -- Arie Rens I assume your client encounters a 'not enough memory to chain' errormessage from CHAIN.COM? The memory it refers to is called the stack by CHAIN.COM (you will see the 'remaining stack' when you type CHAIN without parameters), but you may know it better as the DOS environment space Unfortunately, it seems that the environment space is trimmed when a DOS command session is opened, at least I have not been able to increase this space before the session is opened So the trick is to increase the available environment space inside the DOS session until it is 'enough' for CHAIN.COM. How much is enough? As a rule of thumb the 'remaining stack' when you type CHAIN without parameters must 1200 or more. So how do you increase the available environment space? The only method I found is to reduce the length (and sometimes the number) of the environment variables. When a command session is opened it makes a local copy of those variables, so you can trim and/or remove all the variables you don't for the program you are running. A good place to start is usually the PATH command. I assume you use a batchfile to call CHAIN.COM (if you don't, create one). Inside this batchfile, before the line where you call CHAIN.COM, set the PATH to the minimum directories you need for your program. If trimming and/or removing the existing environment variables is not enough (remaining stack stays below 1200), the next step is to create some dummy environment variables in your window environment (e/g DUMMY1, DUMMY2 etc), and to set them to 250 characters each in the windows environment. When you open a DOS session the local copies of those variables will be available for you to remove. Printed November 21, 2024, 12:22 pm This article has been viewed/printed 35216 times. |