` Printed Icetips Article

Icetips Article

Par2: Switching between EIP and form entry
1998-11-12 -- Jim DeFabia
 
>I have a browse where sometimes I'd like to be able to EIP the few
>fields displayed, while other times I need the form to do it properly.
>
>As soon as I enable EIP in the IDE, the browse goes 100% EIP and I
>can't seem to get to the form.

The ABC templates make this easy to do. I wrote an article for Clarion
Online (Jan 1998 vol. 1 # 6) detailing the steps to set this up.

If you are a subscriber, you may want to read this back issue. If not, here
is the short version of what you need to do:

First, look at what a Browse Procedure does when the user calls for an
update. It calls a method named something like BRW1.ThisWindow.Run. The
method takes a number as a parameter. This number is the value of the
BRW1.AskProcedure property.

In other words, if you enable Edit-In-Place _and_ specify an update
procedure, you have two-thirds of your work already done. Set the
BRW1.AskProcedure Property to 0 (zero) and you have Edit-in-Place; Set it
to >1 (One) and you call your update procedure.

The steps:

1. Select the Browse procedure, and press the Properties button.

2. In the UpdateButton section of the Procedure Properties window, check
    the Use Edit in Place box. Make sure  an update procedure is specified.

3. Embed the code to set the default update action to call the form. In the
    Window Manager Method - Init - BYTE() embed point embed the following code.
    Leave the Priority set to Default (4000).

BRW1:AskProcedure = 1              ! note that  a 1 calls the form--the
   default action we want

4. Embed the code to set the action of a double-click to use edit-in-place.
    In the Browser Method Executable Code Section- Browse on  using
    BrowseClass - TakeKey - BYTE() embed point embed the following code:

    IF RECORDS(SELF.ListQueue) AND KEYCODE() = MouseLeft2
      BRW1.AskProcedure=0
    END

    (Set the Priority to First or 0. It should precede the generated code. )


5. Finally, embed the code to set the action back after an edit (either from
    a form or from an edit-in-place. In the Browser Method Executable Code
    Section- Browse on  using BrowseClass - ASK-BYTE(request), BYTE embed
    point embed the following code:

    BRW1.AskProcedure = 1

This is important. It resets the value to call the form.

Set the Priority to Last or 10000. It should follow generated code.

6. Compile and run the application. Call the browse procedure and notice
    the behavior-a double-click gets you edit-in-place and any other method of
    calling an update gets you the form.

Printed November 23, 2024, 3:41 am
This article has been viewed/printed 35203 times.