Login
Templates, Tools and Utilities
for Clarion Developers
Templates, Tools and Utilities
|
||
|
|
|
Add a comment to an Icetips ArticlePlease add your comments to this article.
Please note that you must provide both a name and a valid email address in order
for us to publish your comment. Comments are moderated and are not visible until they have been approved. Spam is never approved!
Back to article list Search Articles Add Comment Printer friendly Direct link Icetips Products: Using the "Pause the process" button template 2004-04-02 -- Arnor Baldvinsson The pause button can be used to run the same report multiple times. We discovered that this causes a
small problem with the Checkbox Fixer since it had already been run on the report and wasn't prepared to
run again. The results were that the first run worked fine, but any subsequent runs didn't apply the
checkbox fixer at all.
The solution was simple. Put the following code in the Accepted embed of the Pause button:
Today is November 23, 2024, 2:19 am This article has been viewed 35262 times. Google search has resulted in 8 hits on this article since January 25, 2004.
|
|